Again I want to stress if you are configured in a RAID array, do NOT perform the following procedure, you will lose data. Before you remove hard drives, some configuration work must be performed. In my case, there was an extra SATA data and power cable available. The primary OS drive can be unplugged from the SAS/RAID bay and plugged into one of the two SATA ports. The SATA ports are not part of the SAS/RAID controller. My motherboard also contains two SATA headers: SATA_0 and SATA_1. If your system is setup with the "Non-Raid" configuration, please read on. My system was not using a RAID array, both of my hard drives were configured as "Non-Raid". SAS_0 is used to control the 4 built-in hard drive bays in the computer case. My motherboard contains two SAS headers: SAS_0 and SAS_1. If your motherboard has a SATA port, please read on. This method simply bypasses the RAID Controller on the motherboard. I have found a workaround that allows Windows 10 Update to work on motherboards with an Intel C600 Chipset SAS RAID Controller. Solution For Windows 10 Update | Intel C600 Chipset SAS Raid Incompatibility SetupRST -Nodrv Īlthough those drivers are not formally supported under Windows 10, in my experience (again, with an older chipset) they work fine. SetupRST -Noservice (If you don t do this, you *may* get a "Fatal Error" during the driver install because it cannot install the service - at least I did.ģ. (I don't work for Intel)ĭownload link: Download Intel® Rapid Storage Technology (Intel® RST) User Interface and Driverġ. (And in your case, the driver readme specifically mentions your C600 chipset). Hopefully that will work for you as it did for me. Based on my experience with an even older chip set (see thread at particularly the last post - it is on the second page), what I'd suggest is that you install RST driver level13.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |